Mold Inspection In
Hobe Sound

Hobe Sound sits on a narrow strip of mainland with Jupiter Island and the Intracoastal directly to the east, and that geography sets the moisture load. Salt air and wind driven rain come in off the water with very little to slow them down, so east facing walls, window returns and soffits take the worst of it. Summer storms push water sideways into assemblies that shed a vertical rain perfectly well. Add a water table that stays high through the wet season and slabs and lower wall cavities dry slowly, which gives a small intrusion time to sit before anybody notices it.

The housing stock here splits into two different problems. The older stucco and block homes in the established neighborhoods near the water tend to leak at the seams: original aluminum sliding doors, tired sealant around window perimeters, hairline stucco cracking that only matters when the wind is behind the rain. The newer construction in and around Lost Lake and The Soundings has the opposite issue. Those houses are sealed tight and conditioned well, which is fine until a condensate line backs up or a supply line weeps behind a cabinet. A tight envelope holds that moisture instead of letting it pass out through the walls, and the first sign is usually an odor rather than a stain.

A good share of the work in Hobe Sound is on property that sits closed for stretches. A house shut up with the thermostat set high, or a condo between seasons, holds still humid air against interior surfaces for weeks, and growth does not require a leak under those conditions. On the multi family and HOA side around Osprey Cove and the Bridge Road corridor, moisture rarely stays inside one unit. A shared wall, a common attic run or a stacked laundry chase carries it across the line, which is why we map moisture through the whole assembly instead of stopping at the unit you called us about.